 |
 |
 |
 |
Tired of knobs breaking in your props? We are too! Electronic knobs were not designed for the harsh world of escape rooms. That is why we created this device. Available in 1/4" or 1/2" shaft options, this knob will stand up to the worst of most players.
Great pre-wired turn-key kit in the half in configuration.
Built from steel, aluminum, and engineering plastics, this thing is tough. It can hold up an full grown mechanical engineer standing on the knob end. That's about 200lbs.
How it works: The knob assembly is mounted to a base plate supporting the knob shaft. The back of the shaft, the side inside the block, has a special magnet attached to it. That magnet it detected by the FX51-D or FX51-SEN. They both have the same sensor on board. Together, they can be configured to trigger on any combination of knob rotation position.
The FX51-D is the master in the system and FX51-SEN are daisy-chainable additions, which leads to a much more cost effective solution. The FX51-D is the brains of the operation and supports many configurations and variables, and also houses the logic and 2A, Solid State Relay switch. More on the FX51-D here.
Single knob here.
Sensor SpecificationsInput voltage | 3.3V | Hall Sensor | Advanced Magnetic Sensor |
Magnetic SpecificationsGauss Sensitivity | +/- 430 Gauss |
| Sample Magnet A, .125”x.125”, N42 | 20G from .5” from surface. | K&J D22 | Sample Magnet B, .25”x.25”, N42 | 107G from .5” from surface. | K&J D44 | Sample Magnet C, . 375”x.50”, N42 | 62G from 1.0” from surface. 307G from .5” from surface. | K&J D68 | Sample Magnet D, .5”x.5”, N52 | 69G from 1.75” from surface. 236G from 1.25” from surface. | K&J D88-N52 | When using the same magnet in two positions, the goal is to stay within the sensitivity range but provide enough ‘margin on each side for accurate detection and discretion (difference between the two). When combined with utilizing both poles, 4 or more combinations can be accurately detected. | Magnetic field calculator and magnets available at https://www.kjmagnetics.com/ |
|
|
|
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
More Information
1. Please check out our knowledge base for both Escape Room Techs provided support documentation: https://bit.ly/2USxGTK
2. Our Escape Room Techs User Group is a great place to chat with fellow Bad ASS controller owners about how they are using the tech in their escape room: https://bit.ly/2V8fRPC
3. Like all our products, we are working hard to constantly make them even better. If you have an issue you do not see addressed in any of our documentation, feel free to reach out to our awesome support team and we can assist. Contact us here: https://bit.ly/2V8fRPC
|
|
 |
 |
 |
 |


|