 |
 |
 |
 |
Tired of knobs breaking in your props? We are too! Electronic knobs were not designed for the harsh world of escape rooms. That is why we created this device. Available in 1/4" or 1/2" shaft options, this knob will stand up to the worst of most players.
Built from steel, aluminum, and engineering plastics, this thing is tough. It can hold up an full grown mechanical engineer standing on the knob end. That's about 200lbs.
How it works: The knob assembly is mounted to a base plate supporting the knob shaft. The back of the shaft, the side inside the block, has a special magnet attached to it. That magnet it detected by the FX51D or FX51SEN. They both have the same sensor on board. Together, they can be configured to trigger on any combination of knob rotation position.
The FX51D is the master in the system and FX51SEN are daisy-chainable additions, which leads to a much more cost effective solution. The FX51D is the brains of the operation and supports many configurations and variables, and also houses the logic and 2A, Solid State Relay switch. More on the FX51D here.
4 Knob Kit here.
*Note: Actual body color is black.
Demo of 4 Indestructible Knobs with FX51 sensors/controllers
|
|
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
More Information
Steel shaft
Aluminum knob
Engineered plastic holder
4 screws to securely mount to your prop
Other knobs available! Just ask!
1/4" and 1/2" shaft sizes to fit your project
|
|
 |
 |
 |
 |


|