**Notice: Our FX350 based, preconfigured games have been replaced with our Bad ASS Controller. They are web browser configurable and support many more games. Please check them out.**
Sequence Game controller with up to 5 inputs/outputs. Connect buttons, switches, FX50s, or reed switches to the inputs. The outputs are used to drive lights (or anything else) and will play back the programmed sequence as a hint to the players. A magnet is used to start and the learning sequence. Once the sequence is learned (up to over 100 steps), the output will trigger. Outputs will control lights or other devices for player feedback. Based on the FX350, the controller comes preconfigured with the game loaded. Wiring diagrams are provided.
The provided software will monitor the inputs, record the sequence, and remember through power down cycles. After the game has been reset, or a power on event, the output lights will illuminate in the programed sequence. Next, the inputs look for the programmed input sequence. If an input error is detected, the routine will reset and look for the proper sequence again. When then full and proper sequence has been entered via the inputs, the puzzle is solved and a relay will trigger.
Be sure to order a power supply and a hook up kit (available soon) for easy installation. Also, depending on where you want to mount the controller, you may also want an enclosure.
This kit will save time and money by providing a turnkey controller with control room monitoring via the Ethernet connection. The puzzle can be remotely reset, solve status monitored, or force solved (let the players think the puzzle was solved in case of error or inability).