Home > Accessories > Wiring kit
Sort By:
Page of 1
1000, 1K Resistors Pull Up Resistors - 1K (for 12V systems)

Box of 1000, 1K metal film resistors for generic Arduino boards (Raspberry PI as well) because the internal pull-up resistor value is not sufficient for off-board, real world applications.  Suitable for 5V and 12V systems.  Consider using 2, one as a pull-up and one as series protection device.  Add a capacitor for additional filtering capabilities!  Proven to help in building more reliable escape room props and controllers.

: $18.00
I2C Amplifier and Distribution Board - FX14-AMP I2C Amplifier and Distribution Board - FX14-AMP

Extend I2C signals far!  Use one on either end.  I2C in -> I2C out.

: $45.00
I2C Distribution Board - FX14-DIST I2C Distribution Board - FX14-DIST

I2C Distribution board for better layout of I2C cables.  

: $22.00
1 Light and 1 Button Install Kit 1 Light and 1 Button Install Kit

Get control to your escape room! The combination of a push button and a status light mounted on a stainless-steel wall plate creates a professional presentation and installation for remotely controlling your room. This rugged and simple design provides a user interface for your game master to control the room.

Designed for use with FX350 Room Controller, the button and light typically are used to start a room and let the game master know when the room timer is running. However, when connected to the FX350 and appropriate room control software, the button and light can be configured to do most anything.

: $40.00
2 Lights and 2 Buttons Install Kit 2 Lights and 2 Buttons Install Kit

Get control to your escape room! The combination of two push buttons and two status lights mounted on a stainless-steel wall plate creates a professional presentation and installation for remotely controlling your room. This rugged and simple design provides a user interface for your game master to control the room.

Designed for use with FX350 Room Controller, one button and light typically are used to start a room and let the game master know when the room timer is running. The second button and light typically start the video and advise if the room is in use. However, when connected to the FX350 and appropriate room control software, the button and light can be configured to do most anything.

Want less? Check out the one light/one button version here.

: $50.00
I2C 4 Pin Jumper Cables 6" Length I2C 4 Pin Jumper Cables 6" Length

I2C Jumper Cables,  6" Length

: $3.00
I2C 4 Pin Jumper Cables 12" Length I2C 4 Pin Jumper Cables 12" Length

I2C Jumper Cables, 12" Length, 4 conductor.

: $4.00
I2C 6 Pin Ribbon cables 12" Length I2C 6 Pin Ribbon cables 12" Length

I2C Ribbon cables 12" Length

: $10.00
I2C 6 Pin Ribbon cables 48" Length I2C 6 Pin Ribbon cables 48" Length

I2C Ribbon cables 48" Length

: $15.00